In the majority of cases, most people spend quite a bit of money buying their forklift. Therefore, it is very essential to take proper care of it so as to protect your investment well into the long run. It is a great idea to know the procedures that are undertaken during the maintenance and care of this piece of equipment.
By starting up the forklift and listening closely how it runs is one of the best ways to tell how good the engine is running. Like for example, if there are any knocks or misses, the machine is faulty and this should raise some issues. What's more listen carefully for any squealing noise that come from the belts since these sounds will provide you with a lot of information.
Some of the main parts needing attention during maintenance comprise the safety warning devices, gauges, horn, the lights and the overhead guard. Any faulty parts or burnt out light bulbs must be replaced as soon as they are noticed. It is also essential to inspect the wiring.
After the above components have been checked thoroughly, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them properly. Every battery cell should be checked in order to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters must be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
Once the oil change has been done and new filters have been fitted, visually inspect the drive axle from beneath the machine. Be certain to grease the axle if there is any grease fitting. Check the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. Next, inspect each and every other part of the machinery like the wheels. If any type of fault or concern is detected, be sure to deal with it immediately so as to make certain the machine is running at its safest and optimum levels.